Operation
Restoring default (as delivered) settings
6
EDK82ZBC DE/EN/FR 3.1
61
Parameter ändern u speichern----(DUMMYSEITEVOR)---
ActionResultKey
sequence
Step
z Loading parameter sets (PARx and FPAR1):
– Restore default (as delivered)
settings in the selected
parameter set of the standard
device and in the fieldbus
function module
61 PAR1 and FPAR1 are loaded:
Ö ”61” is set
62 PAR2 and FPAR1 are loaded:
Ö ”62” is set
63 PAR3 and FPAR1 are loaded:
Ö ”63” is set
64 PAR4 and FPAR1 are loaded:
Ö ”64” is set
7. Start copying
STOre
or
LOAd
The selected parameter sets are loaded into the
standard device or into the function module.
When STOrE or LOAd stops being displayed, the
default (as delivered) settings have been restored.
8. Enable controller
The drive starts running again.
To Next Page
Loading...
