Need help?Do you have a question about the Lenze ESV371N02YXB571 and is the answer not in the manual?
General| Type | DC Drive |
|---|---|
| Frequency | 50/60 Hz |
| Enclosure Rating | IP20 |
| Communication Interface | CANopen |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overtemperature |
Outlines conformity, approvals, and environmental conditions for the SMV inverter.
Explains the model number structure and lists available SMV inverter types.
Lists output current, mains current, and heat loss for various SMV models.
Specifies dimensions, mounting requirements, and conduit hole sizes for NEMA 1 models.
Details the procedures for connecting power and wiring the SMV frequency inverter.
Provides guidelines for shielded cabling and installation to meet EMC standards.
Recommends fuse types, breaker sizes, and wire gauges for power connections.
Details the function of control terminals, serial communication ports, and terminal strip descriptions.
Explains the operation of the SMV drive's local keypad, display, and buttons.
Describes how the drive displays information and the different operating modes available.
Outlines the process of setting and changing drive parameters using the keypad or EPM.
Explains the function and usage of the Electronic Programming Module (EPM) for parameter storage and transfer.
Introduces the parameter menu structure and basic setup parameters for the SMV drive.
Details essential setup parameters like start control, reference source, and frequency limits.
Covers parameters related to digital and analog input/output configuration for control.
Explores advanced settings like carrier frequency, boost, and current limit adjustments.
Details parameters for configuring the Proportional-Integral-Derivative (PID) control loop.
Configures parameters specific to Vector control mode for advanced motor control.
Sets up communication protocols, network addresses, and timeouts for network control.
Provides read-only access to drive status, faults, and operational data for diagnostics.
Monitors the status of control terminals and drive protection features via LED indicators.
Shows the status of keypad buttons, indicating when they are pressed.
Details Modbus registers for drive control, status, and custom commands.
Explains the bit mapping for the Drive Status Word register.
Lists fault codes and their corresponding descriptions for diagnosing drive issues.
Details drive states and their numerical representations for status monitoring.
Describes the binary representation of digital input statuses.
Defines control bits for network commands, speed references, and stop actions.
Explains how to override the drive display with custom text or data.
Lists status and warning messages, their causes, and suggested remedies for troubleshooting.
Explains the 4-digit codes indicating drive configuration and control source.
Provides comprehensive descriptions of drive faults, their causes, and troubleshooting steps.
To Next Page