Lenze EZAMBHXX028 - About this Document; Document Description; Further Documents

About this document
WARNING!
Read this documentaon carefully before starng any work.
▶
Please observe the safety instrucons!
Document descripon
This document describes the mounng of the following accessory sets:
•
EZAMBHXX028 switch/potenometer set
•
EZAMBHXX035 black pushbuon
•
EZAMBHXX036 red pushbuon
•
EZAMBHXX037 selector switch
•
EZAMBHXX038 potenometer
•
EZAMBHXX039 blue signal lamp
•
EZAMBHXX040 red signal lamp
•
EZAMBHXX041 green signal lamp
You will nd informaon on wiring and commissioning in the mounng and switch-on instrucons
of the inverter.
General informaon
Device-specic standards and direcves
•
The product meets the protecon requirements of the Low-Voltage Direcve 2014/35/EU.
•
The harmonized standard EN 61800-5-1 is used for the inverters.
•
The inverters are cered according to UL 61800-5-1.
•
Installaon in accordance with NFPA 70 (Naonal Electrical Code) and NFPA 79 (Electrical Standard for
Industrial Machinery) for the USA, and CSA 22.1 (Canadian Electrical Code) for Canada.
Relevant standards and direcves for the operator and commissioner
•
No machine may be started up or switched on in connecon with this product unl it has been ensured
that the enre machine complies with the regulaons of the Machinery Direcve 2006/42/EC and the EN
60204-1 standard.
•
Intended commissioning and operaon are only permied if the EMC Direcve 2014/30/EU is complied
with.
Further documents
Informaon and tools with regard to the Lenze products can be found on the Internet:
www.Lenze.com à Downloads
About this document
Further documents
12