Maintenance
Important notes
7
41
Lenze ¯ MA 12.0013 ¯ 3.0
7 Maintenance
7.1 Important notes
Note!
¯ Gearboxes below 200 Nm are lubricated for life.
¯ The mechanical power transmission system is maintenance−free.
7.2 Maintenance intervals
Dust deposits prevent heat to be emitted and cause a high housing temperature. The
gearboxes/geared motors must be purified of dirt and dust at regular intervals.
¯ In the case of gearboxes that are not lubricated for life, the lubricant must be
replaced at regular intervals.
– The type of lubricant is indicated on the nameplate. Replace the lubricant only
with the same type of lubricant.
– The lubricant change depends on the lubricant temperature, see Fig. 11.
1. Measure the lubricant temperature at the drain plug,
2. Add 10 °C,
3. Read the changing interval from the diagram.
A
100
60
1000
10000
50000
70
80
90
110
B
C
D
Fig. 11 Lubricant diagram
Oil sump temperature [°C]
Synthetic oil CLP HC/CLP PG
Oil life/changing intervals [operating
hours h]
Mineral oil CLP
¯ Shaft seals and roller bearings:
– The service life depends on the operating conditions.
– Replace seals in case of leakage to avoid consequential damage.
Stop!
For drive systems: Also observe the maintenance intervals for the other
drive components!
To Next Page
Loading...
