Lenze i5CA Series - Page 8

2.2 Mounng steps
You need:
•
Torx scr
ewdriver TX20
1. Preparaon:
1. Insert the shield sheet into the slot on the back side unl it engages.
2. Mounng:
1. Hook the control unit into the upper mounng slots.

2. Turn it downwards unl it engages into the lower mounng slots.
2 Mounng
Mounng steps
6
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com