Control technology| System manual
System description
System components
20 L DMS 1.3 EN - 02/2011
L-force Motion
In contrast to L-force Logic, L-force Motion serves to trigger controllers in addition to pro-
cessing PLC programs.
In addition to all functions of the L-force Logic, also Soft Motion functions are supported
according to PLCopen part I and II.
L-force Motion is available for the following target platforms:
Industrial PCs:
– Embedded Line EL 1800-9800
– Command Station CS 5800-9800
– Control Cabinet CPC 2800
L-force Visu
The L-force Visu runtime software serves to extend your IPC to a visualisation device. The
visualisation can be installed on a separate IPC but can also run on the same IPC in parallel
to the control. There are different options for the communication interface connection.
The resulting four options and their advantages and disadvantages are described in the fol-
lowing.
L-force Visu is available for the following target platforms:
Industrial PCs:
– Embedded Line EL 1800-9800
– Command Station CS 5800-9800
– Control Cabinet CPC 2800
HMIs:
–EL 100
– EL 100 PLC
To Next Page
Loading...
Need help?
General
