8 Commissioning and operation
Functional test
8.3 Functional test
• Check all functions o f the drive after com m issioning:
• Direction of rotation of the motor
- Direction of rotation in the disengaged state (see chapter ’ Electrical
connection”).
• Torque behaviour and current consum ption
• Function o f the feedback system
8.4 During operation
@ Stop!
• Fire hazard! Do not clean or spray m otors w ith flam m able detergents
or solvents.
• Avoid overheating! Deposits on the drives im pede the heat dissipation
required and have to be removed regularly.
EN
А Danger!
During operation, m otor surfaces m ay not be touched. According to the
operating status, the surface tem perature for m otors can be up to 150°C.
For the protection against burn injuries, provide protection against
contact, if necessary. Observe cooling-off tim es!
During operation, carry out inspections on a regular basis. Pay special attention to:
• Unusual noises
• Oil spots on drive end or leakages
• Irregular running
• Increased vibration
• Loose fixing elem ents
• Condition of electrical cables
• Speed variations
• Im peded heat dissipation
- Deposits on the drive system and in the cooling channels
- Pollution of the air filter
In case o f irregularities or faults: (Ш 45).
38
Lenze • BA 33.0006 • 3.0
To Next Page
Loading...
