Lenze p300 - Application as directed; Open source notice; Important notes

5
KFZ_Zeichen_EN−M−Install_WiHis_Panel_Controller
Lenze ¯ MA_p300 ¯ 7.0
Application as directed
The Panel Controller/HMI is an electrical equipment ...
ƒ for installation (horizontal, vertical or display above) into control cabinets or similar
closed electrical operating areas;
ƒ for implementing control and operating concepts or for presenting information in
usual industrial and commercial fields.
Max. operation ambient tempe-
rature
10.9 cm (4.3") 17.8 cm (7.0") 26.4 cm (10.4")
Standard PROFINET Standard PROFINET Standard PROFINET
According to EN 60721−3−3: 3K3 50 °C 45 ° C 55 °C 45 °C 55 °C 45°C
According to UL ^ 10
A different use, or one beyond these purposes, is not permissible!
In order to ensure the protection of persons and material assets, higher−level safety systems
must be used!
Open source notice
Lenze Software may contain software elements that are licensed as free software or open
source. The licensing terms and conditions of the open source software components used
in this product can be found in the "License" directory on the SD card incl. in the product.
Important notes
ƒ To prevent damage to electronic components, only mount/remove the device with
the voltage supply switched off.
ƒ The device contains electrostatically sensitive components. The personnel must be
free of electrostatic charge prior working on the device.
ƒ In the installation space, continuous and sufficient air circulation is absolutely
required to dissipate the heat of the device. The ventilation slots must not be
covered.
ƒ When selecting the installation space, be sure to observe an ergonomic position of
the screen and pay regard to the incidence of light, which may cause reflections on
the screen. Protect the device from direct solar radiation, as the housing may heat up
considerably.
ƒ During mounting, there is a danger that the device will fall out of the mounting
cutout. You should secure it to prevent this happening until it have been fitted.
ƒ During mounting, the gasket of the front frame is exposed and can be damaged.
Before mounting, make sure that the gasket is undamaged. Protect the gasket
against ultraviolet rays.
ƒ The device must be securely seated in the mounting cutout and the front panel seal
must be correctly fitted. Otherwise, class of protection IP65 will not be achieved on
the front side of the device! (IP rating is not UL−approved.)
ƒ The device has to be powered with a PELV supply.
ƒ The voltage input is not fused internally. Observe the max. permissible input voltage
and professionally fuse the device on the input side against voltage fluctuations and
voltage peaks.