Lerdge iX Usage Manual

www.lerdge.com
1
Lerdge-iX Usage Steps
Content
1. Select the power input voltage ................................................................................................... 2
2. Turn on the printer ..................................................................................................................... 2
3. Introduction of the key interface ................................................................................................. 3
4. Check the function of endstops.................................................................................................. 4
5. Check the function of motors ..................................................................................................... 4
6. Adjust the Z-axis origin position ................................................................................................. 5
7. Homing each axis ...................................................................................................................... 6
8. Check the travel space .............................................................................................................. 6
9. Level the print platform .............................................................................................................. 7
10. Check the leveling effect ......................................................................................................... 8
11. Preheating the hotend ............................................................................................................ 8
12. Load filament .......................................................................................................................... 9
13. Print the first model ............................................................................................................... 10
14. Fine-tune the Z-axis for the first layer ................................................................................... 10
15. Pause, stop and resume printing .......................................................................................... 12
16. Automatically turn off the printer after finish .......................................................................... 13

Lerdge iX Specifications

General

Build Volume	300 x 300 x 400 mm
Bed Temperature	Up to 120°C
Display	4.3-inch Touch Screen
Firmware	Lerdge Firmware
Power Supply	24V
Filament Diameter	1.75 mm
Nozzle Diameter	0.4 mm (default)
Print Speed	Up to 150 mm/s
Supported Materials	PLA, ABS, PETG, TPU, Wood
Frame Material	Aluminum
Connectivity	USB, SD Card