34
How do I Input tHe tempeRatuRe and altItude at wHIcH tHe StRIkInG
dIStance foR eacH club waS meaSuRed? (GX-2i only)
The procedure for inputting the temperature and
altitude at which each striking distance was measured
begins immediately after inputting the specific club dis-
tances. Follow each of the steps above under “How Do
I Activate the Club Selector?” and “How do I input the
striking distance of the 8, 6 and 4-iron?” Once the strik-
ing distances have been input, press MODE and follow
the steps below:
1) The last saved temperature will be flashing in the bottom portion of
the display. If you wish to input a temperature other than the one
shown, proceed to step 2. To save the shown temperature, press MODE
and skip to step 3 below.
2) Press POWER to begin incrementing through the temperature settings.
The default setting is 75 degrees F. Pressing POWER will increment
through a range of 30 degrees to 120 degrees F in 5 degree increments.
When the appropriate temperature is displayed, press MODE to save
your selection and move on to the altitude input.
2
3
4
5
6
7
8
9
P
To Next Page
Loading...
Need help?
General
