19
TO INPUT THE TEMPERATURE AND ALTITUDE AT WHICH THE
STRIKING DISTANCE FOR EACH CLUB WAS MEASURED:
The procedure for inputting the temperature and altitude at
which each striking distance was measured begins immediately
after inputting the specific club distances. Follow each of the
steps under, “To Input The Striking Distance Of The 8, 6 and
4-iron”. Once the striking distances have been input, press MODE
and follow the steps below:
1) The last saved temperature will be flashing
in the bottom portion of the display. If you
wish to input a temperature other than the
one shown, proceed to step 2. To save the
shown temperature, press MODE and skip to
step 3 below.
2) Press and release POWER to begin
incrementing through the temperature settings. The default
setting is 75 degrees F (25 degrees C). Pressing POWER will
increase in 5 degree increments through a range of 30 degrees
to 120 degrees F (0 degrees to 50 degrees C). When the
appropriate temperature is displayed, press and release MODE
to save your selection and move on to the altitude input.
3) The last saved altitude will be flashing in the bottom portion
of the display. If you wish to input an altitude other than the
one shown, proceed to step 4. To save the shown altitude
in
cm
M
Y
ft
L
O
S
C
L
U
B
T
G
R
To Next Page
Loading...
Need help?
General
