Leuze electronic
Short instructions IT 6300 Leuze electronic Page
12
IT6300 to PS2 interface
The operation of the IT 6300 in keyboard-wedge mode is described in this chapter. A PC keyboard is
emulated in this operating mode. The data which are read in are written directly to the currently activated
program. Thus, the data can be processed further in all standard programs.
Required parts:
1x 501 05 380 IT 6300 IDP 351S
1x 501 05 424 Cable PS2 for IT 6300
1x 501 03 403 Power supply unit
Please connect the IT 6300 acc. to the adjacent figures.
To do this, proceed as follows:
1. Switch off the PC.
2. Disconnect the keyboard.
3. Plug in the IT 6300 hand-held scanner between the
keyboard and the PC.
4. Switch the PC back on.
5. Scan the code shown below.
Configuration
PS2 keyboard emulation with CR LF
German keyboard
Disconnect
To Next Page
Loading...
Need help?
General
