LevelOne DSA-1000 User Manual

- 14 -
4.2 Gateway/Controller
Configuration procedures are similar on all Gateway/Controller models, the following instruction steps uses
WHG-1000 as illustration. Note: the screenshots may be slightly different for your Gateway/Controller
model.
Step1:
Connect administrator PC to your Gateway/Controller and access the WMI (web management interface).
Step2:
Enter the configuration page of the Service Zone which DSA-1000 will be connected to. Check to make
sure that the network settings of DSA-1000 are under the same subnet as this service zone.

LevelOne DSA-1000 Specifications

General

Brand	LevelOne
Model	DSA-1000
Category	Printer
Language	English