EasyManuals Logo

Leviton 7000 Series User Manual

Leviton 7000 Series
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
5
CAUTIONS:
This product is not intended for life or safety applications.
• Do not install this product in hazardous or classied locations.
The installer is responsible for compliance with all applicable codes.
• Mount this product inside a suitable re and electrical enclosure.
If the collector is connected directly to a source of voltage, the pulse isolator burns out
immediately and becomes non-responsive.
• Do no use any cleaning agents, including water, on the device.
No accessories are approved for use with the meter other than those specied in the
Leviton Manufacturing product literature and price sheets.
A circuit breaker used as a disconnect must meet the requirements of IEC 60947-1 and
IEC 60947-3 (Clause 6.11.4.2).
Current transformers may not be installed in equipment where they exceed 75 percent
of the wiring space of any cross-sectional area within the equipment.
Current transformers may not be installed in an area where they block ventilation openings.
• Current transformers may not be installed in an area of breaker arc venting.
Not suitable for Class 2 wiring method nor intended for connection to Class 2 equipment.
Secure current transformer and route conductors so that they do not directly contact live
terminals or bus.
External secondary inputs and outputs should be connected to devices meeting the
requirements of IEC 60950.
The following additional requirements apply for recognized board versions of the
VerifEye
®
meter:
• For use only with listed energy-monitoring current transformers.
Associated leads of the current transformers shall be maintained within the same
overall enclosure.
Unless the current transformers and their leads have been evaluated for
REINFORCED INSULATION, the leads must be segregated or insulated from
different circuits.
The current transformers are intended for installation within the same enclosure as the
equipment. These may not be installed within switch gears and panel boards
or similar.
• Use this device with copper or copper-clad wire only.
• For indoor use only.
1 WARNINGS AND CAUTIONS
WEB VERSION

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Leviton 7000 Series and is the answer not in the manual?

Leviton 7000 Series Specifications

General IconGeneral
BrandLeviton
Model7000 Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals