11
CARE & MAINTENANCE
Replacing the Remote Control
Battery
Replacing the Fuse
Cleaning the Tower Fan
• Unplug before cleaning.
• Wipe the outside of the tower fan with
a soft, dry cloth. If necessary, wipe
the housing with a damp cloth, then
immediately dry.
• Use a vacuum, duster, or compressed air
to clean the inside of the tower fan.
• If necessary, use a screwdriver to remove
the back cover and clean the inside of
the tower fan. [Figure 2.1]
If not using the tower fan for an extended
period of time, cover the tower fan and store
in a cool, dry place to avoid moisture damage.
Storage
Figure 2.2
Figure 2.1
Figure 2.4
Figure 2.3
1. Insert a coin/button battery into the slot
and rotate counterclockwise to remove
the battery compartment [Figure 2.2].
1. Unplug the tower fan. Grab the plug and
pull from the outlet. Never pull from the
power cord.
2. Open the fuse cover on the plug by
sliding the fuse cover toward the
metal prongs. [Figure 2.3]
3. Carefully remove the blown fuse with
tweezers or a small tool. Make sure
not to break the glass fuse.
4. Risk of fire: Only
replace the fuse with
a 2.5 Amp, 125V fuse
(3.6 x 10 mm). Do not
use any other type of
fuse. [Figure 2.4]
CAUTION: RISK OF FIRE
Do not replace the plug if it is damaged.
If the plug is damaged in any way, stop
using the tower fan and contact Customer
Support (see page 15).
Open
• Do not clean with abrasive chemicals or
flammable cleaning agents.
Rotate
Remove
Note: If the replacement fuse blows,
a short-circuit may be present. Please
contact Customer Support (see page 15).
5. Slide the fuse cover closed.
Note:
• Make sure the tower fan is turned o before
removing the back cover.
•
Clean the internal parts with a dry cloth.
2. Remove the old
battery.
3. Replace with a new
3V CR2025 battery.
Make sure the
polarities match.
4. Replace the battery
compartment.
To Next Page
Loading...
Need help?
General
