Levoit Vista 200 - KEEPING THINGS CLEAN (CONT.); Check Filter Indicator Functionality; Cleaning the True HEPA Filter; Replacing the Air Filter

10
Resetting the Check Filter
Indicator
Reset the Check Filter Indicator when:
A.
lights up.
1. Replace the air filter.
2. Turn on the air purifier.
3. Press and hold
for 3 seconds.
4.
will turn o when successfully
reset.
B. The air filter was changed before
lit up.
1. Press and hold
for 3 seconds.
This will turn on
.
2. Press and hold
again for 3
seconds.
3.
will turn o when successfully
reset.
1. Unplug the air purifier. Flip the air purifier
over and remove the filter cover cap and
filter cover (see Getting Started, page 6).
2. Remove the old air filter.
3. Clean any remaining dust or hair inside
the purifier using a vacuum hose. Do not
use water or liquids to clean the purifier.
[Figure 3.1]
4. Unwrap the new air filter and place it
into the housing (see Getting Started,
page 6).
5. Replace the cover and cap. Plug in the
air purifier.
6. Reset the Check Filter Indicator.
Replacing the Air Filter
Figure 3.1
will light up as a reminder to check the air
filter. Depending on how much you use the
air purifier, the indicator should turn on within
6–8 months. You may not need to replace
your filter yet, but you should check it when
turns on.
Check Filter Indicator
The True HEPA Filter should be cleaned
once a month to increase the eciency and
extend the life of your filter. Clean the inside
and outside of the filter using a soft brush or
vacuum hose to remove hair, dust, and large
particles. Do not clean the filter with water or
other liquids.
Cleaning the Air Filter
If not using the air purifier for an extended
period of time, wrap both the purifier and the
filter in plastic packaging and store in a dry
place to avoid moisture damage.
Storage
KEEPING THINGS CLEAN (CONT.)