v
CREATIVE FREEDOM
PRESERVE YOUR
MULTI-PATTERN FLAGSHIP WITH THE OPTION TO
ADJUST THE POLAR PATTERN AFTER RECORDING
// LCT 640 TS
QUICKSTART GUIDE
// User Interface
1 Polar pattern indicator // Use center pushbutton to select polar
pattern; omni // broad // cardioid // super cardioid // gure-8.
Not illuminated in Dual Output Mode!
2 Low-cut indicator // Use left pushbutton to change the low-cut
settings. Activate the low-cut to get rid of unwanted low frequencies
and structure born noise.
3 Status indicator //
Illuminated white: standard operation
Illuminated green: Dual Output Mode
Flashing red: clipping occurs
Not illuminated: key-lock active
4 Pre-attenuation indicator // Use right button to select the pre-
attenuation. Use this setting to avoid clipping when recording very
loud sound sources.
5 Pushbuttons
Key-lock // Hold the left pushbutton for more than 2 seconds to
activate the key-lock mode. Now all pushbuttons are locked until
you press the left button for 2 seconds again.
Clipping History // Hold the right pushbutton for more than 2 seconds to enter clipping history. If the status indicator ashes
green/white no clipping occured. If the status indicator ashes red/white clipping occurred. The illuminated pre-attenuation
symbols show at which pre-attenuation setting the clipping occurred. Press any button for more than 2 seconds to exit clipping
history. Once you exit the clipping history or remove 48V the history is deleted.
// Multi-pattern mode
The multi-pattern mode is the typical implementation for dual diaphragm studio microphones. Select one of ve polar patterns
before you start recording.
Setup // Use a standard 3 pin XLR cable to connect the LCT 640 TS to your microphone preamp, mixing console or audio
interface. The LCT 640 TS requires 48V phantom power, make sure to turn on the phantom power on your microphone preamp!
// Dual Output Mode
The Dual Output Mode is a unique feature of the LCT 640 TS. It enables you to record the front and back diaphragm of the
capsule separately. Now it is possible to change and ne-tune the polar pattern in post-production. You can even “turn” the
microphone 180° without touching it.
Setup // Use a 3 pin XLR cable to connect output A to your microphone preamp, audio interface or mixing console.
Connect output B with the included adapter cable to your microphone preamp, audio interface or mixing console.
Turn on 48V phantom power on both channels.
To activate Dual Output Mode press and hold the center pushbutton for 2 seconds!
Make sure to set the input gain on your preamp to the same value for both channels!
Make sure to download our Polarizer plugin and experiment with different settings!
// Record MS Stereo with one LCT 640 TS
Select Dual Output Mode, turn the front of the microphone to the source you want to record, then turn it 90° counter clockwise.
Record both outputs of the microphone on a stereo track, front capsule is the left channel, back capsule is the right channel.
Adjust the stereo width by adjusting the panorama; pan hard left and hard right for maximum stereo effect, pan both to the center
and you get one mono signal as omni polar pattern.
Best results will be somewhere in between!
1
2
3
5
A
4
B
LEWITT
®
Burggasse 79
1070 Vienna, Austria
www.lewitt-audio.com
To Next Page
Need help?
General
