MIDI Program Change Map
Pgm Chg # Loop mode Sample mode Echo mode
1 tap tap tap
2 reset (punch-in) reset bypass
3 reset (phrased) reset bypass
4 replace (punch-in) forward/reverse divide by 2
5 replace (phrased) forward/reverse divide by 2
6 layer forward/reverse divide by 3
7 mute (punch-in) forward/reverse divide by 4
8 mute (phrased) forward/reverse divide by 4
9 fade short audio threshold 1 feedback 1
10 fade medium audio threshold 3 feedback 3
11 fade long audio threshold 5 feedback 5
12 cue loop 1 audio threshold 7 feedback 7
13 cue loop 2 audio threshold 9 feedback 9
14 cue loop 3 audio threshold 11 feedback 11
15 cue loop 4 audio threshold 13 feedback 13
16 cue loop 5 audio threshold 15 feedback 15
17 cue loop 6 - feedback 16
18 cue loop 7 - -
19 cue loop 8 - -
20 mute/restart - -
26
All front panel controls can be accessed
via MIDI Program Change messages as
shown. These messages are recognized on
MIDI Channel 1.
Recognition of these messages can be
temporarily disabled, or assigned to another
MIDI Channel with the following power-up
procedure:
1. Simultaneously press RESET/BYPASS,
and FUNCTION, while applying power to
the unit. A "d" should appear on the
display.
2. Press RESET/BYPASS, then turn the
Mode knob until "15" is displayed.
3. Press RESET/BYPASS. The display will
show "1", and the edit indicator will ap-
pear. Turn SELECT to assign 0 (off) or
MIDI Channel 1-16.
4. Press RESET/BYPASS, then turn the
Mode knob until "9" is displayed. Press
RESET/BYPASS again to resume nor-
mal operation with the new assignment.
MIDI Implementation Notes
To Next Page
Loading...