Lexicon MC-12 V3.0 - SERIAL COMMUNICATIONS PROTOCOL DEFINITION REV 1-5 - MC-12 Parameter Notification by ID (MC-12)

Lexicon, Inc.
MC-12 Serial Communications Protocol Printed on: 08/18/03
© 2003 Lexicon, Inc. All rights reserved. 13 of 94
7.1.5 MC-12 Parameter Notification by Id (MC-12)
MC-12 will transmit parameter change notifications if they are enabled using the command described in
7.3.42 (MC12_Set_Parameter_Notification_By_Id). If a parameter value is changed due to any user action
or system action the MC-12 will transmit the current value of the parameter that is changing.
7.1.5.1 Command Packet Description
Application Header:
Command MC_PARAM_NOTIFICATION_BY_ID 0x05
Data Count 24 0x18
Application Data:
Data[0] ParamId(LSB) nn
Data[1] ParamId(MSB) nn
Data[2] ParamType nn
Data[3-23] Value[0 -20]
nn nn
nn…
7.1.5.2 Data Description
Same as Paragraph 7.3.37.2
7.1.5.3 HOST Response
The MC-12 does not expect any response from the HOST.
7.1.5.4 Defaults
The following Parameters Notifications are Enabled in the MC-12 default state: