MC-8 Setup
3-29
SIDE L/R FULL, FULL + SUB, 30 to 120Hz, THX 80Hz, NONE
Assigns a crossover point for the Main Zone audio output connectors
labeled SIDE L/R when a custom speaker setup is selected.
•Select FULL to send a full-range signal to the side speakers.
Otherwise, select the crossover point closest to the low-
frequency rating of the side speakers.
•Select FULL + SUB to send a full-range signal to the side
speakers and duplicate bass frequencies to the SUB output.
(The set crossover point of the SUB parameter determines the
upper range of duplicate bass.) Selecting the FULL + SUB option
can result in excessive bass.
• When the speaker setup does not include side speakers, select
NONE to redirect side channel signals to the Rear L/R output
connectors. If the REAR L/R parameter is also set to NONE, the
MC-8 will redirect surround channel signals to the Front L/R
output connectors.
Note:
When the SIDE L/R parameter is set to NONE, Dolby Digital Surround
EX, THX Ultra2, THX Surround EX, DTS(-ES) decoding, the ASA
parameter and PLIIx modes are not available.
When a THX speaker setup is selected, a THX 80Hz crossover point is
applied to the SIDE L/R output connectors, and the SIDE L/R
parameter cannot be adjusted.
REAR L/R FULL, FULL + SUB, 30 to 120Hz, THX 80Hz, NONE
Assigns a crossover point for the Main Zone audio output connectors
labeled REAR L/R when a custom speaker setup is selected.
• Select FULL to send a full-range signal to the rear speakers.
Otherwise, select the crossover point closest to the low-
frequency rating of the rear speakers.
• Select FULL + SUB to send a full-range signal to the rear
speakers and duplicate bass frequencies to the SUB output.
(The set crossover point of the SUB parameter determines the
upper range of duplicate bass.) Selecting the FULL + SUB option
can result in excessive bass.
• When the speaker setup does not include rear speakers, select
NONE
to redirect rear channel signals to the Side L/R output connectors. If
the SIDE L/R parameter is also set to NONE, the MC-8 redirects
surround channel signals to the Front L/R output connectors.
Note:
When the REAR L/R parameter is set to NONE, Dolby Digital Surround EX,
THX Ultra2, THX Surround EX, PLIIx modes, DTS(-ES) decoding and the ASA
parameter are not available.
When a THX speaker setup is selected, the REAR L/R parameter opens
the THX REAR SPEAKERS menu which is used to activate or deactivate
the REAR L/R output connectors.
To activate and configure the Rear L/R output connectors for a
7.1-channel THX speaker, setup select THX 80Hz. To deactivate the
Rear L/R output connectors and configure the Main Zone audio output
connectors for a 5.1-channel THX speaker setup, select NONE.
SPEAKERSSETUP CUSTOM SETUP SIDE L/RSET CROSSOVERS
SPEAKERSSETUP
SET CROSSOVERS
THX SETUP
SPEAKERSSETUP CUSTOM SETUP REAR L/RSET CROSSOVERS
SPEAKERSSETUP THX SETUPSET CROSSOVERS
To Next Page
Loading...
Need help?
General
