2-11
Basic Operation
Row 2
Card
2.0 Bank Copy
This control allows you to copy banks of effects from one location to another.
Banks can be copied internally, or to and from PCMCIA Memory Cards. Try, for
example, copying Preset Bank 0 into the internal Register Bank.
1. Press Store. The following display will appear briefly.
The display will then change to show:
Select and copy
effect banks
Card Bank Copy
2.0 Src: ✱P0 Dst: R
The asterisk indicates that Src is available for adjustment. ADJUST will
scroll through all available banks, including internal preset and register
banks, as well as any banks on inserted PCMCIA cards. Internal banks are
labeled "P0...P3" and "R1". Card registers will be labeled "C0, C1, C2" etc.
2. Press Load/✱ to move the asterisk to Dst.
Card Bank Copy
2.0 Src: P0 Dst: ✱R
Now, use ADJUST to select the destination of your copy. Selecting a
register bank here will cause its contents to be erased and overwritten
with the bank you have selected as the source when Store is pressed.
4. Press Store to copy the selected source (in this case Preset Bank 0) into the
internal Register Bank. The display will ask "Are you sure?" (Press STORE).
Press any button to cancel. Press Store to complete the store operation.
2.1 Load
This control allows you to load audio software from a Memory Card simply by
inserting the new card and responding to the display prompts. The PCM 81 can
load all PCM 80 algorithm cards. It can also share registers, maps, and chains
with the PCM 80 via RAM cards. (Sharing Setups between the PCM 80 and the
PCM 81 is not recommended.)
To Next Page
Loading...
