LexiconPCM 81 User Guide
2-36
Continuing the previous example, we’ll adjust the rate of the LFO by jumping to
it from the Patch row.
Press Load/✱ repeatedly to return to the Patch 1 Source selection display.
Adjusting the modulation
source parameters
Int LFO
Patch 1 ✱ Src
■ Mod : LFO ✱ Rate
8.0 0.21 Hz
The display now shows position 8.0 in the Edit matrix Mod Row. The small
square in the upper left corner of the display is a patch source indicator. This
indicator appears whenever a modulator (such as the LFO in this example) has
been assigned as a patch Source in the effect being edited.
Turn ADJUST to change the LFO rate to 0.10Hz.
Press Edit to jump directly to the LFO parameters in the Mod row.
The asterisk (✱) indicates that LFO Rate will be altered when
you turn ADJUST. Press Load /✱ to change the selection to
the other LFO parameters ( Shape, P Width and Depth).
Patch Source Indicator
■ Mod : LFO ✱ Rate
8.0 0.10 Hz
Now, press Edit to jump back to your previous position in the Patch row.
Int LFO
Patch 1 ✱ Src
To Next Page
Loading...
