character at the location marked by the cursor. Turn SELECT to
move the cursor to another position. Press Store twice to execute.
2.4 Labels
This control allows you to rename
Register bank and row labels. Any
changes made here are executed
immediately. To rename bank and
row labels, press Store and use
ADJUST to display any bank. Press
Load/✱ to access the naming
function for the selected bank, then
use ADJUST and SELECT to enter a
new bank name.
Press Load/✱ to display the first row in the selected bank. Use
ADJUST to select any other row within the bank. Press Load/✱ to
access the naming function for any displayed row, then use ADJUST
and SELECT to enter a new bank name. Pressing Load/✱ from the
row label naming display will jump you back to bank selection.
ROW 3 MIDI
3.0 Reset
This control resets all patched parameters to their previously stored
values. When this control is activated, a MIDI "Reset All Controllers"
message is also transmitted on the current channel by the PCM 91.
This display allows you to assign a name (of 10 characters or less)
to the card. A blinking cursor indicates that a particular character
is available for changing. Use ADJUST to select the character you
want in that position. Turn SELECT to move the cursor to another
character. Press Store to execute. The display will ask "Are you
sure?" (Press STORE). Press Store again to complete the operation.
Press any front panel button to cancel.
2.3 Name
This control allows you to rename a formatted card. Insert a
formatted card and press Store. The card name will appear with the
blinking cursor as shown above. Use ADJUST to select a new
2-12
Basic Operation
Lexicon
ROW 2 CARD (continued)
2.2 Format
This control allows you to format a Memory Card for PCM 91 use.
(Make sure the Write Protect switch on the card is set to Off.) Insert
an unformatted card (or one you don't mind erasing), then press
Store. The display will ask "Are you sure?" (Press STORE). Press
Store. The following display will appear briefly.
Format and name
memory card
Name: N ew Card
(press STORE)
The display will then change as shown below.
PCM 91 Character Set
! “ # $ % & ‘ ( ) * + , - . / 0 1 2 3
4 5 6 7 8 9 : ; < = > ? @ A B C D
E F G H I J K L M N O P Q R S T U
V W X Y Z [ ¥ ] ^ _ ‘ a b c d e f g
h i j k l m n o p q r s t u v w x y z
{ : } ~ z (space)
The @ and the $ symbols are used
to represent Custom Control values.
To Next Page
Loading...
