77
Media guidelines
Loading transparencies
Before loading transparencies, fan the stack to prevent
sheets from sticking together. To prevent print quality
problems, avoid getting fingerprints on the transparen-
cies.
Load transparencies only in the multipurpose feeder or
tray 1. Your printer does not feed transparencies from
tray 2 or tray 3.
Load transparencies with the corner notch oriented as
shown. This properly positions the specially coated print
side. For more information, refer to the detailed loading
instructions packaged with the transparencies.
Note:
To create a straight
paper path and minimize curling,
load transparencies in the multi-
purpose feeder and stack them
in the rear output bin.
When loading transparencies in tray 1, use the piece of
cardboard with the rectangular cutout that comes with the
transparencies. Place the cardboard in the bottom of the
tray before loading transparencies. The cardboard ensures
proper feeding of the last transparency in the stack.
Only use the cardboard when loading transparencies in
tray 1. Do not use the cardboard in the multipurpose
feeder.
Notch
Multipurpose feeder
Tray 1
Notch
Cardboard
To Next Page
Loading...
