15
IPDS Printer and Host Setup Guide PSF/MVS LAN Printing Using the Standard Network Port or Internal Print Server
Steps
The following steps must be completed to begin printing IPDS jobs.
1
Choose a Printer Port for Printing IPDS Jobs
2
Define the printer to JES
3
Add the printer to the PSF STARTUP PROC
4
Configure the Printer’s Print Server TCP/IP Settings
5
Select the IPDS Emulation, Bar Code Size, Host Resolution, and Fax Interrupt Settings
6
Verify IPDS Printing
7
Troubleshooting
Step 1 Choose a Printer Port for Printing IPDS Jobs
Several printer ports are available for receiving IPDS jobs when using the printer Standard Network port or the
MarkNet internal LAN print server. The printer port will be used in one of the following steps.
Port descriptions:
• Port 5001 - This is the recommended port selection for receiving IPDS jobs. This port is only used for
receiving IPDS jobs.
• Port 9600 - This port is only provided for compatibility with some older printers.
NOTE: Some previous printers supported port 9100 for IPDS printing. If you are replacing a printer using port
9100, change to port 5001.
To Next Page
Loading...
Need help?
General