Command Description Supported
PARC
2
in Path, draw ARC Yes
PAT select fill PATtern Yes
PCRP
2
in Path, Curve to Relative Position No
PCZP
2
in Path, Curve to Zero-relative Position No
PDIR
2
set Print DIRection Yes
PDRP
2
in Path, Draw to Relative Position Yes
PDZP
2
in Path, Draw to Zero-relative Position Yes
PIE draw PIE chart Yes
PMRA
2
in Path, Move to Relative position specified by Angle Yes
PMRP
2
in Path, Move to Relative Position Yes
PMZP
2
in Path, Move to Zero-relative Position Yes
!R! PRESCRIBE start sequence Yes
RDMP
3
Received-data DuMP No
RES RESet Yes
RPF Return to Previous Font Yes
RPG
2
Return to Previous Graphics state Yes
RPP Return to Previous Position Yes
RTXT print Right-aligned TeXT Yes
RVCD
2
ReceiVe Compressed raster Data No
RVRD ReceiVe Raster Data Yes
SBM Set Bottom Margin Yes
SCAP
2
Set line CAP Yes
SCF Save Current Font Yes
SCG
2
Save Current Graphics state Yes
SCP Save Current Position Yes
SCPI Set Characters Per Inch Yes
SCRC Set Command Recognition Character Yes
SCS Set Character Spacing Yes
SDP
2
Store Dash Pattern Yes
SEM
1
Set Emulation Mode Yes
1
Partial support or extended support (see next section for details)
2
PRESCRIBE II option
3
Not applicable (for example, unsupported paper option or diagnostic command)
4
Custom command extension, not part of standard PRESCRIBE language
PRESCRIBE commands
8
To Next Page
Loading...
Need help?
General