Lexmark C500n - User Settings; Config Menu

6
Using printer menus
User Settings
Note: An asterisk (*) next to a value indicates the default setting.
Config Menu
Configuration options for the printer that control how the printer functions.
Menu selection Purpose Values
Timeout Specifies the amount of time in
seconds before a timeout occurs.
The timeout causes the printer’s
reception of print data to be
suspended. It then causes the
printer to forcibly output the partially
received data so it can receive new
print data. The result may be a
printout with partial loss of data, an
incorrect printout, or no printout.
5 to 999 (300*)
OFF
SleepMode Specifies whether or not to use the
printer’s power saver feature.
ON* The printer enters sleep mode when
the time specified in "SleepTime"
has passed.
OFF The power saver feature is disabled.
SleepTime Specifies the amount of time (in
minutes) the printer waits after a job
is printed before it goes into a
reduced power state.
30M*, 60M, 120M,
240M, 5M, and 15M
Port Specifies which interface port to be
used.
AUTO* Specifies both the LAN port and the
USB port. Either port is
automatically used according to the
setting of the Priority submenu.
NET Specifies the LAN port. This setting
option prohibits the printer from
receiving print data through the
USB port.
USB Specifies the USB port. This setting
option prohibits the printer from
receiving print data through the LAN
port.
Priority Specifies priority between the LAN
interface port and the USB interface
port when both of them are enabled
in the Port submenu.
AUTO* The printer alternately uses the LAN
port and the parallel port for
receiving print data.
NET The printer prioritizes the LAN port
for receiving print data, sometimes
causing no output of print data via
the USB port.
USB The printer prioritizes the USB port
for receiving print data, sometimes
causing no output of print data via
the LAN port.