9
Using printer menus
Administrative Settings
The Admin menus consist of the Utility Menu, Network Menu, and Toner Sense Menu. To access these menus:
1 Make sure the printer is on and the Ready message appears.
2 Press .
4 Press and hold for 3 seconds until you see Utility Menu.
5 Press to choose either the Utility Menu, Network Menu, or Toner Sense Menu, and then press to enter
the menu.
Utility Menu
The Utility Menu is used when resetting maintenance items or restoring factory defaults.
Network Menu
The Network Menu is used for setting up the internal network adapter.
Menu selection Purpose Values
Clear Belt CG Resets the count for the
photodeveloper cartridge.
Not Execute
Execute
If Not Execute is selected, then the
User-defined settings remain.
To Execute:
1 Press to choose Execute, and
then press to perform the
action.
2 Once the action is performed,
press to return to Ready.
Clear Fuser Resets the count for the Fuser.
Clear Print Info Resets the page count for the
printer to zero.
Setting default Returns printer settings to the
factory default values.
Tray2 Margin Specifies the adjustment value
of the tray 2 paper feed.
Note: This setting will only be
available if the optional 530-
sheet drawer is installed.
-35–35 (0*) 1 Press to choose the value, and
then press to save.
2 Once the action is performed,
press to return to Ready.
Menu selection Purpose Values
Ip Addr Sets the network port address. 0.0.0.0 * to
255.255.255.254
1 Press to choose the menu
item, and then press .
The address is now available for
input.
2 Press to change the first value
(or hold down to scroll faster),
and then press to save and
move to the next value.
3 Repeat until the desired address is
entered.
4 Once the address is entered, press
to return to Ready.
Subnet. Mask Sets the network port subnet
mask.
Gateway Addr Sets the network port gateway
Address.
3 Press
To Next Page
Loading...
