8
Using printer menus
TestMode Specifies the media type and print
mode when printing the test page,
configuration page, network
configuration page, and status
page.
Note: If you select a setting other
than TRANS, the specified media
type applies to printing regardless
of the actual type of media in the
selected input tray. Be sure to select
an applicable setting option in this
submenu.
PLAIN* Select this for printing on plain
paper (75g/m² to 89g/m²).
TRANS Select this for printing on OHP film
(transparency). Printing with this
option stops until the media in tray 1
is replaced with a transparency.
LABEL Select this for printing on labels.
THIN Select this for printing on light
weight paper (60g/m² to 74g/m²).
MTHICK Select this for printing on thick
paper (90g/m² to 104g/m²).
THICK1 Select this for printing on thick
paper (105g/m² to 163g/m²).
THICK2 Select this for printing on thick
paper (164g/m² to 210g/m²).
ENV1 Select this for printing on envelopes.
ENV2
Menu selection Purpose Values
To Next Page
Loading...
