Lexmark C500n - Ordering a Fuser; Ordering a Waste Toner Bottle; Ordering a Photodeveloper Cartridge

Using the media support in the output bin
37
Media specifications
Using the media support in the output bin
Use the media support so a stack of media does not skew in the output bin. To use the media support:
1 Grasp the edges of the media support at the indentations in the output bin.
2 Lift the media support.
3 Lower the media support into place so that it is now at an angle.
The media support is inclined so your stacked media now remains in a neater stack in the output bin.
Note: Do not leave the media support inclined if you are printing transparencies.