Lexmark C500n - Troubleshooting; Solving Basic Printer Problems; Checking an Unresponsive Printer

Administration
63
7
Administration
The following sections are for a network administrator in charge of the printer.
Memory requirements
Your printer ships with 64MB of memory for fast, efficient processing of color jobs.
Restoring factory default settings
When you first enter the printer menus from the operator panel, you may notice an asterisk (*) next to a value in the menus.
This asterisk indicates the factory default setting. These settings are the original printer settings. (Factory defaults may vary
for different countries.)
When you select a new setting from the operator panel, an asterisk appears next to the setting to identify it as the current
user default setting. These settings are active until new ones are stored or the factory defaults are restored.
To restore the original printer factory default settings:
1 Make sure the printer is on and the Ready message appears.
2 Press .
3 Press and hold for 3 seconds until you see Utility Menu, and then press .
4 Press until you see Setting Default, and then press .
5 Press until you see Execute, and then press .The factory default settings are restored.
6 Press to return to Ready.
If you need more information about changing menu settings or selecting new user default settings, see the Menus and
Messages Guide on the Software and Documentaion CD.
Adjusting power saver
To adjust the SleepTime (power saver) setting in the Config Menu:
1 Make sure the printer is on and the Ready message appears.
2 Press .
3 Press until you see Config Menu, and then press .
4 Press until you see SleepTime, and then press .
5 Press until you see the desired number of minutes, and then press . Minute settings available range from
5–240. If needed, the power saver can also be Disabled . For more information on disabling the power saver, see
Disabling and enabling power saver.
6 Press to return to Ready.