Property Description Default
ui.logging Determines whether the test is logged in Log4J
false
Basic (e‑Task) prompting properties
Property Description Default
basic.addressRange The IP addresses used for emulated e‑Task printers. A single IP may
be used to emulate multiple e‑Task printers at a single address, since
the emulator can use multiple HTTP connections for e‑Task. Multiple
addresses are specified as a range, in the format
xxx.xxx.xxx.xxx‑xxx.xxx.xxx.xxx, and each included
address must be bound to a network adapter in the local computer.
If multiple addresses are specified, then only the first is used unless
basic.multiIP is set to true.
Local IP address
(set
autotmatically
when the
simulator is
started)
basic.scanfiles The TIFF, JPEG, PDF, or PostScript files to use in simulating the scan
task. The setting can contain a comma‑delimited list of multiple files,
which are submitted together for the scan task.
Note: The delimiter used in the list can be changed using the
scanFileDelimiter property.
None
basic.promptAnswers A comma‑delimited list of answers to supply for prompts asked by
the profile. If left blank, the default response is used for all prompts.
If you need to supply an answer for any prompt, then you must
supply all answers for the applicable logic path.
For more information, see “Supplying answers to prompts” on
page 61.
Note: The delimiter used in the list can be changed using the
delimiter property.
None
basic.repetitions The number of repetitions for the test on each emulated printer.
Use 0 for both this property and basic.nummfps to enter
discovery mode.
0
basic.nummfps
The number of printers to emulate for the test. Use 0 for both this
property and basic.repetitions to enter discovery mode.
Note: It is not recommended to emulate more than 250 printers.
0
basic.bind Determines whether to bind the local IP address to the print listener
for receiving print jobs
true
basic.prompting Indicates to the application whether the profile contains prompts
true
basic.scanning Indicates to the application whether the profile contains a scan task
true
basic.profilerunTimeThreshold The time in milliseconds allowed for a profile to run before a warning
message is logged
30000
basic.timeToFirstPromptThreshold The time in milliseconds allowed for the first prompt in the profile
to display before a warning message is logged
2000
Testing and deploying workflow solutions 55
To Next Page
Loading...
