Lexmark C792 - Page 56

Property Description Default
basic.multiIP Determines whether multiple IP addresses are used for emulating
multiple e‑Task printers. If false, then only the first address
specified for basic.addressRange is used. If true, then the
number of addresses specified for basic.addressRange must
match the number specified for basic.nummfps.
true
(automatically
changed to
false if the
test is run
without
specifying
multiple
addresses)
basic.readTimeout The timeout in milliseconds for reading data from the LDD system
360000
basic.connectionTimeout The timeout in milliseconds for connection requests to the LDD
system
180000
native
This property should always be false for LDD 4.x. false
basic.useRandomFileFromDirectory Determines whether a random file is used from the folder specified
in basic.randomFileDirectoryPath for simulating the
scan task. When set, these properties override files specified for
basic.scanfiles.
false
basic.randomFileDirectoryPath Specifies the folder where image files for scans can be found when
basic.useRandomFileFromDirectory is set to true
None
Advanced (e‑Task 2) prompting properties
Property Description Default
advanced.promptAnswers A comma‑delimited list of answers to supply for prompts asked
by the profile. If left blank, the default response is used for all
prompts. If you need to supply an answer for any prompt, then
you must supply all answers for the applicable logic path.
For more information, see “Supplying answers to prompts” on
page 61.
Note: The delimiter used in the list can be changed using the
delimiter property.
None
advanced.addressRange The IP addresses used for emulated e‑Task 2 printers. A single
IP may be used to emulate multiple e‑Task 2 printers at a single
address, since the emulator can use multiple HTTP connections
for e‑Task 2. Multiple addresses are specified as a range, in the
format xxx.xxx.xxx.xxx‑xxx.xxx.xxx.xxx, and each
included address must be bound to a network adapter in the
local computer. If multiple addresses are specified, then only
the first is used unless advanced.multiIP is set to true.
Local IP
address (set
autotmatically
when the
simulator is
started)
advanced.repetitions The number of repetitions for the test on each emulated printer.
Use 0 for both this property and advanced.nummfps to
enter discovery mode.
0
Testing and deploying workflow solutions 56