Property Description Default
advanced.nummfps
The number of printers to emulate for the test. Use 0 for both
this property and advanced.repetitions to enter
discovery mode.
Note: It is not recommended to emulate more than 250
printers.
0
advanced.multiIP Determines whether multiple IP addresses are used for
emulating multiple e‑Task 2 printers. If false, then only the
first address specified for advanced.addressRange is
used.
true
(automatically
changed to
false if the
test is run
without
specifying
multiple
addresses)
advanced.profilerunTimeThreshold The time in milliseconds allowed for a profile to run before a
warning message is logged
30000
advanced.timeToFirstPromptThreshold The time in milliseconds allowed for the first prompt in the
profile to display before a warning message is logged
2000
advanced.useSecureWebdav Determines whether WebDAV communication with the LDD
system should be secure. This property should be true when
the LDD system is v4.4.0.2 or later, or false when the LDD
system is v4.4.0.1 or earlier.
true
advanced.webdavUsername The user name used for secure WebDAV communication with
the LDD system. In most cases, this property should not be
changed.
ldd
advanced.webdavPassword The password used for secure WebDAV communication with the
LDD system. In most cases, this property should not be changed.
ldd
advanced.useRandomFileFromDirectory Determines whether a random file is used from the folder
specified in advanced.randomFileDirectoryPath for
simulating scan tasks. When set, these properties override files
specified for advanced.scanfilesN.
false
advanced.randomFileDirectoryPath Specifies the folder where image files for scans can be found
when advanced.useRandomFileFromDirectory is
set to true
None
advanced.scanfiles1–
advanced.scanfilesN
The TIFF, JPEG, PDF, or PostScript files to use in simulating scan
tasks. Each property represents a single scan task, so properties
after advanced.scanfiles1 are only used for profiles that
contain multiple scan tasks. Each property can contain a
comma‑delimited list of multiple files, which are submitted
together for the scan task.
Note: The delimiter used in the list can be changed using the
scanFileDelimiter property.
None
Testing and deploying workflow solutions 57
To Next Page
Loading...
