EasyManuals Logo

Lexmark CS417 User Manual

Lexmark CS417
209 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #151 background imageLoading...
Page #151 background image
All life indicators are designed to function with Lexmark supplies and parts, and may deliver unpredictable
results if third-party supplies or parts are used. Imaging component usage beyond the intended life may
damage your Lexmark printer or its associated components.
Warning—Potential Damage: Use of third-party supplies or parts can aect warranty coverage.
Damage caused by the use of third-party supplies or parts may not be covered by the warranty.
To accept any and all of these risks, and to proceed with the use of non-genuine supplies or parts in your
printer, press
and on the control panel simultaneously for 15 seconds to clear the message and
continue printing.
If you do not want to accept these risks, then remove the third-party supply or part from your printer and
install a genuine Lexmark supply or part.
Note: For the list of supported supplies, see the “Ordering supplies” section or go to
www.lexmark.com.
Printer had to restart. Last job may be incomplete.
From the printer control panel, press to clear the message and continue printing.
For more information, go to
http://support.lexmark.com or contact customer support.
Reinstall missing or unresponsive [color] cartridge [31.xy]
Try one or more of the following:
Install the missing toner cartridge. For more information, see the “Replacing supplies” section of the
User’s Guide.
Remove the unresponsive cartridge, and then reinstall it.
Note: If the message appears after reinstalling the supply, then the cartridge may be defective.
Replace the cartridge.
Reinstall missing or unresponsive black and color imaging kit and all
cartridges [31.xy]
Try one or more of the following:
Check if the imaging kit is missing. If missing, then install the imaging kit.
For information on installing the imaging kit, see the “Replacing supplies” section.
If the imaging kit is installed, then remove and reinstall the unresponsive imaging kit.
Note: If the message appears after reinstalling the supply, then replace the imaging kit. The imaging
kit may be defective or a nongenuine Lexmark supply. For more information, see
“Using genuine
Lexmark parts and supplies” on page 109.
Troubleshooting 151

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lexmark CS417 and is the answer not in the manual?

Lexmark CS417 Specifications

General IconGeneral
BrandLexmark
ModelCS417
CategoryPrinter
LanguageEnglish

Related product manuals