Additional printer setup
Installing internal options
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware
or memory devices sometime after setting up the printer, then turn the printer o, and unplug the power
cord from the electrical outlet before continuing. If you have any other devices attached to the printer,
then turn them o as well, and unplug any cables going into the printer.
You can customize your printer connectivity and memory capacity by adding optional cards.
Available internal options
Memory cards
•
DDR3 DIMM
• Flash memory
– Fonts
– Firmware
• Forms Barcode
• Prescribe
• IPDS
• Hard disk
*
*
This internal option is available only in CS510 printer model.
Additional printer setup 16
To Next Page
Loading...
Need help?
General
