Lexmark CS735 - Page 174

Error codes Error message Solution
32.xy Replace unsupported fuser.
1 Open door A, and then open
door A1.
CAUTION—HOT
SURFACE: The inside of the
printer might be hot. To reduce
the risk of injury from a hot
component, allow the surface to
cool before touching it.
2 Locate the fuser type at the
bottom of the fuser.
Notes:
• All printer models except
Lexmark CS737 support the
fuser types 00, 01, and 02.
• Lexmark CX737 only
supports fuser type 05.
3 If the fuser is not supported,
remove the fuser, and then install
a supported one. For more
information, see
“Replacing the
fuser” on page 152.
33.40, 33.41, 33.42, 33.43 Non-Lexmark [color]
cartridge, see User's Guide.
For more information, see
“Non‑Lexmark supply” on page 225.
33.60 Non-Lexmark black imaging
unit, see User's Guide.
For more information, see
“Non‑Lexmark supply” on page 225.
33.64 Non-Lexmark color imaging
kit, see User's Guide.
For more information, see
“Non‑Lexmark supply” on page 225.
37.1 Insufficient memory to
collate job.
Try one or more of the following:
• To uc h Continue to print the part
of the job that is stored and to
begin collating the rest of the print
job.
• Cancel the current print job.
Troubleshoot a problem 174