Lexmark CX410de - Page 86

Actions Yes No
Step 4
Check the following values at JFUSES1:
Pin 1: +24 V dc (door closed)
Pin 2: +24 V dc (doors closed)
Pin 3: +24 V dc (doors closed)
Pin 4: +24 V dc (doors closed)
Pin 5: Between 0.6 and 3.28 V dc
Pin 6: Ground
Pin 8: Ground
Pin 10: Between ‑3 and +3.3 V dc
Pin 11: Ground (no wire)
Are the values correct?
Go to step 6. Replace the controller
board. See “Controller
board removal” on
page 239.
Step 5
Replace the fuser. See “Fuser assembly removal” on page 257.
Does the error clear?
Problem resolved. Replace the controller
board. See “Controller
board removal” on
page 239.
7527
Diagnostic information
86