5 Insert the toner cartridge into the photoconductor kit by aligning the rollers on the toner cartridge with the tracks.
Push the toner cartridge in until it clicks into place.
6 Install the unit into the printer by aligning the arrows on the guides of the unit with the arrows in the printer. Push
the unit as far as it will go.
7 After you replace the photoconductor kit, reset the photoconductor counter. To reset the counter, see the
instruction sheet that came with the new photoconductor kit.
Warning—Potential Damage:
Resetting the photoconductor counter without replacing the photoconductor kit
may damage your printer and void your warranty.
8 Close the front door.
Maintaining the printer
10
To Next Page
Loading...
Need help?
General
