Photoconductor kit end-of-life
40
Maintaining the printer
Changing a photoconductor kit
Warning: When replacing a photoconductor kit, do not leave the new photoconductor kit exposed to direct light
for an extended period of time. Extended light exposure can cause print quality problems.
1 Turn the printer off.
2 Remove the print cartridge assembly.
a Press the button on the left side of the printer to release the front door.
b Lower the front door.
c Grasp the toner cartridge handle, and pull up and out.
Note: Do not press the button on the print cartridge assembly
Place the print cartridge assembly on a flat, clean surface.
3 Remove the toner cartridge:
a Press the button on the base of the print cartridge assembly.
b Grasp the toner cartridge handle, and pull up and out.
4 Unpack the new photoconductor kit.
To Next Page
Loading...
