Lexmark E450DN - Adding a Memory Card; Adding a Flash Memory Card

Adding a memory card
33
Installing options
Adding a memory card
The system board has one connector for an optional memory card.
Note: Memory options designed for other Lexmark printers may not work with your printer.
1 Access the system board (see Accessing the system board on page 30).
2 Push open the latches on both ends of the memory connector.
3 Unpack the memory card.
Warning: Memory is easily damaged by static electricity.
Touch something metal, such as the printer frame,
before you touch a memory card.
Avoid touching the connection points along the edge of the card.
4 Align the notches on the bottom of the card with the notches on
the connector.
5 Push the memory card firmly into the connector until the
latches on either end of the connector snap into place.
It may require some force to fully seat the card.
6 Make sure each latch fits over the notch on each end of the
card.
7 Close the side access door.
8 Close the rear exit.
9 Close the front door.
Adding a flash memory card
The system board has two connectors for an optional flash memory card.
Note: Flash memory card options designed for other Lexmark printers may not work with your printer.
1 Access the system board (see Accessing the system board on page 30).
2 Unpack the flash memory card.
Warning: Flash memory is easily damaged by static electricity. Touch
something metal, such as the printer frame, before you touch
a flash memory card.
Avoid touching the connection points along the edge of the card.
CAUTION: If you are installing a memory card after setting up the printer, turn the printer off, and
unplug the power cord from the wall outlet before continuing.
CAUTION: If you are installing a flash memory card after setting up the printer, turn the printer
off, and unplug the power cord from the wall outlet before continuing.