$%?!'K9@3',9'-91'F9EE$1!
These are possible solutions. Try one or more of the following:
LDf(':2c('8W DN('P:':(N'NW'WO
From Print Properties or the printer control panel Finishing menu, set Collate to On.
Note: Setting Collate to Off in the software overrides the setting in the Finishing menu.
c(a28('NS('8WLI (XPNh'WR'NS('IcPON'`WT
Reduce the complexity of the print job by reducing the number and size of fonts, the number and complexity of
images, and the number of pages in the job.
LDf(':2c('NS('IcPON(c'SD:'(OW25S'L(LWch
Add printer memory.
2-!"B!F1!,'B$?!'@%!$&3'9FF6%
Increase the Print Timeout value:
1 From the printer control panel, press
.
2 Press the down arrow button until Settings appears, and then press .
3 Press the down arrow button until General Settings appears, and then press .
4 Press the down arrow button until Timeouts appears, and then press .
5 Press the down arrow button until Print Timeout appears, and then press .
6 Press the left or right arrow buttons until the value you want appears, and then press
.
(-M!E9B!'3!$E3'/A!-'B%7-17-?
Due to humidity and heat, some envelopes become sealed during the printing process. If this happens, open the
rear door of the printer to allow envelopes to exit there.
:9EM7-?'9B179-'B%9@E!#3
WB179-',9!3'-91'9B!%$1!'F9%%!F1E<'9%'_6713'$;1!%'71'73'7-31$EE!,
These are possible solutions. Try one or more of the following:
c(:(N'NS('IcPON(c
Turn the printer off, wait for about 10 seconds, and then turn the printer on.
=,!106$%2!!#+"/
C)*
To Next Page
Loading...
