Lexmark E460DN - Page 91

Menu item Description
O!1/9%&'D,,%!33
UAA
LAA
Lets you view the network addresses
`9@'N7#!961
0-225 seconds
Sets the amount of time in seconds that a network print job can take before it
is canceled
Notes:
• 90 seconds is the factory default setting.
• A setting value of 0 disables the timeout.
• If a value of 1–9 is selected, the setting is saved as 10.
T$--!%'I$?!
On
Off
Allows the printer to print a banner page
Note: Off is the factory default setting.
N8IbPI'#!-6
Note: This menu is available only for network models or printers attached to print servers.
This menu is available from the Network/Ports menu:
Network/Ports Network Menu Network Setup TCP/IP
Menu item Description
DF17M$1!
On
Off
Activates TCP/IP
Note: On is the factory default setting.
[7!/'S931-$#!
Lets you view the current TCP/IP hostname
Note: This can be changed only from the Embedded Web Server.
PI'D,,%!33
Lets you view or change the current TCP/IP Address information
Note: Manually setting the IP address sets the Enable DHCP and Enable Auto IP
settings to Off. It also sets Enable BOOTP and Enable RARP to Off on systems that
support BOOTP and RARP.
O!1#$3&
Lets you view or change the current TCP/IP Netmask information
5$1!/$<
Lets you view or change the current TCP/IP Gateway information
(-$@E!'aS8I
On
Off
Specifies the DHCP address and parameter assignment setting
Note: On is the factory default setting.
(-$@E!'cDcI
On
Off
Specifies the RARP address assignment setting
Note: On is the factory default setting.
(-$@E!'TWWNI
On
Off
Specifies the BOOTP address assignment setting
Note: On is the factory default setting.
:"5$,%#("5+"/&3,+"#$,&-$"1%
>C