Lexmark E460DN - Page 98

Menu item Description
I$%$EE!E'/71A'(OD
ENA Address
ENA Netmask
ENA Gateway
• ENA Address sets the network address information for an external print server
that is attached to the printer using a parallel cable
• ENA Netmask sets the netmask information for an external print server that is
attached to the printer using a parallel cable
• ENA Gateway sets the gateway information for an external print server that is
attached to the printer using a parallel cable
Note: Parallel with ENA is available only if the printer is attached to an external print
server through the parallel port.
:LNI':!16B'#!-6
Use the following menu to configure the SMTP server.
Menu item Description
I%7#$%<':LNI'5$1!/$<
I%7#$%<':LNI'5$1!/$<'I9%1
:!F9-,$%<':LNI'5$1!/$<
:!F9-,$%<':LNI'5$1!/$<'I9%1
Specifies SMTP server and port information
Note: 25 is the factory default setting for each SMTP Gateway Port menu
item.
:LNI'N7#!961
5–30
Specifies the amount of time in seconds before the server stops trying
to send the e-mail
Note: 30 seconds is the factory default setting.
c!BE<'D,,%!33
Specifies server information. This is a required item.
Note: The message box has a limitation of 512 characters.
23!'::
Disabled
Negotiate
Required
Sets the printer to use SSL for increased security when connecting to the
SMTP server
Notes:
• Disabled is the factory default setting for Use SSL.
• When the Negotiate setting is used, your SMTP server determines if
SSL will be used.
:LNI':!%M!%'D61A!-17F$179-
None
Plain (Simple)
CRAM MD5
Digest MD5
NTLM
Kerberos 5
Specifies the type of user authentication required for scan to e-mail
privileges
Note: None is the factory default setting.
:"5$,%#("5+"/&3,+"#$,&-$"1%
>Q