Use the To
7 2-Sided/Eco-Mode Activate 2-Sided to:
• Print on both sides of the paper (duplex).
Activate Eco-Mode to:
• Print on both sides of the paper (duplex).
• Change to Power Saver mode after the printer
is left idle for ten minutes.
• Set screen brightness to low.
Note: 2-Sided/Eco-Mode is available only on
select models.
8 Cancel button
• Cancel a print, copy, or scan job in progress.
• Exit from a menu level of the Copy, Scan,
Photo, or File Print menu to the top level of a
menu.
• Exit from a menu level of the Setup menu to
the top level of the previous mode.
• Clear current settings or error messages, and
return to default settings.
9 Display
Note: The display is turned off in Power Saver
mode.
View:
• Printer status
• Messages
• Menus
10 Select button
• Select menu options.
• Save settings.
• Feed or eject paper. Press and hold for three
seconds to feed or eject paper from the
printer.
11 Arrow buttons
• Choose a menu or submenu item that appears
on the display.
12 Back button
• Return to the previous screen.
• Exit from one menu level to a higher one.
13 Setup button Access the setup menu and change printer
settings.
Note: The Copy, Scan, and Photo button lights are
off when this button is selected.
Using memory cards and flash drives
Using a memory card or flash drive with the printer
Memory cards and flash drives are storage devices frequently used with cameras and computers. You can
remove the memory card from the camera or the flash drive from the computer and insert it directly into
the printer.
1 Insert a memory card into the card slot or a flash drive into the USB port.
Inserting a memory card Inserting a flash drive
MEMOR
YSTICK
Notes:
• Insert the card with the brand name label facing
right.
• Make sure any arrows on the card point toward
the printer.
• If necessary, connect the memory card to the
adapter that came with it.
• Make sure that the memory card inserted is
supported by the printer. For more information,
see “Supported memory cards and file types”
on page 8.
FLASH DRIVE
Notes:
• The flash drive uses the same port that is used
for a PictBridge camera cable.
• An adapter may be necessary if your flash drive
does not fit directly into the port.
7
To Next Page
Loading...
