Additional printer setup
Installing internal options
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware or
memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord
from the electrical outlet before continuing. If you have other devices attached to the printer, then turn them
off as well, and unplug any cables going into the printer.
Warning—Potential Damage: Controller board electronic components are easily damaged by static electricity.
Touch a metal surface on the printer before touching any controller board electronic components or connectors.
Available internal options
• DDR3 DIMM
• Flash memory
– Fonts
– Firmware
• Forms Barcode
• Prescribe
• IPDS
• Printcryption
• Hard disk
*
• Internal Solutions Ports (ISP)
*
– Parallel 1284‑B interface
– MarkNet N8130 10/100 fiber interface
– RS‑232‑C serial interface
*
This internal option is available only in the M3150de printer model.
Additional printer setup 13
To Next Page
Loading...
