Load Manual Feeder with [paper type] [paper size] [orientation]
Try one or more of the following:
• Load the feeder with the correct size and type of paper.
• From the printer control panel, press to clear the message and continue printing.
Note: If no paper is loaded in the feeder, then the printer manually overrides the request, and then prints from
an automatically selected tray.
• Cancel the current job.
Maintenance kit low [80.xy]
You may need to order a maintenance kit. For more information, visit the Lexmark Web site at
http://support.lexmark.com or contact customer support, and then report the message. If necessary, press on
the printer control panel to clear the message and continue printing.
Maintenance kit nearly low [80.xy]
For more information, visit the Lexmark Web site at http://support.lexmark.com or contact customer support, and
then report the message. If necessary, press
on the printer control panel to clear the message and continue
printing.
Maintenance kit very low, [x] estimated pages remain [80.xy]
You may need to replace the maintenance kit very soon. For more information, visit the Lexmark Web site at
http://support.lexmark.com or contact customer support, and then report the message.
If necessary, press
on the printer control panel to clear the message and continue printing.
Memory full [38]
Try one or more of the following:
• From the printer control panel, press to clear the message.
• Decrease the resolution setting.
• Install additional printer memory.
Network [x] software error [54]
Try one or more of the following:
• From the printer control panel, press to clear the message and continue printing.
• Unplug the router, then wait for 30 seconds, and then plug it back again.
Troubleshooting 138
To Next Page
Loading...
