Not enough free space in flash memory for resources [52]
Try one or more of the following:
• From the printer control panel, press to clear the message and continue printing.
• Delete fonts, macros, and other data stored in the flash memory.
From the printer control panel, navigate to:
> Settings > > Settings > > Print Settings > > Utilities Menu > > Format Flash > > Yes >
• Use a larger‑capacity flash memory card.
Note: Downloaded fonts and macros that are not stored in the flash memory are deleted when the printer is turned
off or restarted.
Paper changes needed
Try one or more of the following:
• From the printer control panel, select Prompt for each page to continue printing.
• Select Use current supplies to continue printing using the paper loaded in the tray.
• Cancel the current print job.
Printer had to restart. Last job may be incomplete.
From the printer control panel, select Continue to clear the message and continue printing.
For more information, visit
http://support.lexmark.com or contact customer support.
Parallel port [x] disabled [56]
Do either of the following:
• From the printer control panel, select Continue to clear the message and continue printing.
The printer discards any data received through the parallel port.
• Select Reset active bin to reset the bin for a linked set of bins.
Reattach bin [x]
Try one or more of the following:
• Turn off the printer, and then turn it back on.
• Reattach the specified bin.
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the specified bin.
4 Reattach the bin.
Troubleshooting 194
To Next Page
Loading...
