Moving Guide
Before moving the printer
CAUTION—POTENTIAL INJURY: Before moving the printer, follow these guidelines to avoid personal injury or printer
damage:
• Turn off the printer, and then unplug the power cord from the electrical outlet.
• Disconnect all cords and cables from the printer.
• If two or more optional finishers are installed, then remove the finishers individually from the printer.
Notes:
– Make sure to remove the topmost finisher first.
– To remove the finisher, hold the finisher on both sides, and then lift the latches to unlock the finisher.
• If the printer does not have a caster base, then remove the optional trays.
Note: Slide the latch on the right side of the printer toward the front of the printer until it clicks into place.
Moving Guide
Page 1 of 3
To Next Page
