Lexmark MS811dn - Page 2

Doc No.: Rev. 001 Page 2 of 17
Plastic containing brominated flame retardants
3 Fans;
11
Sensors;
8 Fuser
parts
Fan(s) and Sensors (locations
illustrated in 4.2)
Plastic parts located in the fuser
assembly marked with recycle code
that includes "FR17"or “FR16”
Asbestos waste and components which contain
asbestos
0
N/A
Cathode ray tubes
0
N/A
Chlorofluorocarbons (CFC), Hydrochlorofluorocarbons
(HCFC) or Hydrofluorocarbons (HFC), Hydrocarbons
(HC)
0
N/A
Gas discharge lamps
0
N/A
Liquid Crystal Display (LCD) greater than 100 cm
2
and
those back-lighted with Gas discharge lamps
1
MS812de LCD located inside OP
panel
External electrical cables
1
Power cord located on the back lower
left quadrant
Components containing refractory fibres
0
N/A
Components containing radioactive substances
0
N/A
Electrolyte capacitors containing substances of
concern
1
4
Capacitor(s) located on Power Supply
(locations illustrated in 4.2)
1
With (height > 25 mm, diameter > 25 mm or proportionately similar volume)
3. Disassembly tools
4. Disassembly references
4.1. Removal procedure(s)
MS710, MS810 WEEE removal
WEEE materials and components removal procedures are available upon request.
Contact: recycling@lexmark.com
4.2. Graphical illustration of material’s and component’s location
See next page
Item
#2 Phillips screwdriver, magnetic
Wire cutter
E-clip puller or small flat-head screwdriver
Standard slotted head screwdriver